VIS pcb's
Would these be the same as the pcb's in zs vis motors ?
http://www.ebay.co.uk/itm/Rover-75-Z...item417130e1e5 |
May be wrong but I was under the impression the vis motors were all the same. Im sure mine that are currently on the zs were off of a zt when I got them? Wouldve thought they would do the job.
|
If they are, I hope he is prepared for a massive increase in demand
|
Quote:
I was pretty sure they were all the same, but his application lists only show zt/75 so I thought I'd stick the question out there. |
Quote:
|
I just checked the motor part numbers, they are the same for zs/45 and zt/75.
|
Now if he could source oil resistant (brushless) motors these would be fit and forget surely?
|
This is Stocktake (Dave) on the 75/ZT forum who is selling these.
The PCB is for Balance only, and has a facility for adding a test switch, it also has solder pads for adding the outsource motor that he fits. |
Quote:
http://www.75ztcommunity.co.uk/vis-m...-t4384-20.html |
All I know is that the motor are specially made for a company in America.
|
All times are GMT. The time now is 03:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk