Mk1 MG ZS boot lid and spoiler fittings.

[acemodder]

Hey guys

The MK1 Saloon boot lid, is the fitting holes the same for the low spoiler and the extreme spoiler?

Looks like I may have found a replacement boot if so.

[andys1981]

think so mate

[Stephen]

I am sure another 2 need to be drilled, because the extreme is 6 holes and small is 4 holes.

Stephen

[acemodder]

Thats fine, I can manage that

Bought this for ?59.95 delivered. (i reckon I can sell the spoiler for ?20)

http://i406.photobucket.com/albums/pp141/acemodder/boot.jpg

[andys1981]

stephens right the extreme spoiler has 6 screws mate,as i had to drill 6 when i changed the bootlid

[Andyf]

Apparently some people just use the 4 holes when changing from the lower spoiler to the extreme to save drilling more. The threads I have read in the past about it say that no one has a problem with it, especially if you use strong adhesive tape as well as the bolts.

[stamford]

It uses the same 4 off fixing holes as the small spoiler, you can easily drill the other 2 inboard ones by laying masking tape along the boot edge. Use the 4 off existing holes to line the extreme one in position and mark around the remaining 2 off studs. Drill, deburr, clean and protect, job done.