PDA

View Full Version : A little engine bay mod...........


stamford
06-10-07, 06:24 PM
Just did a couple of little mods here, got a load of stainless steel braiding foc from work. Have plenty to do, just that most parts I would like to do will need disconnecting, so not a quick job, may do some over a period of time.

http://i98.photobucket.com/albums/l259/stamfordzs180/MG%20ZS180/DSC05637.jpg

http://i98.photobucket.com/albums/l259/stamfordzs180/MG%20ZS180/DSC05639.jpg

http://i98.photobucket.com/albums/l259/stamfordzs180/MG%20ZS180/DSC05636.jpg

sduk
06-10-07, 06:41 PM
v nice mate! will look sweet when finished, even better cos its free :D

Shafz
06-10-07, 06:43 PM
v nice mate! will look sweet when finished, even better cos its free :D
x2

looks nice and neat mate :smart:

stamford
06-10-07, 06:48 PM
Well, I've seen the other versions used, the plastic ones, but did not like it. The other problem I have is the heatshrink sleeving, I'll need to get some bigger ones!

Thanks guys.

JIMZS180
06-10-07, 07:15 PM
lookin good mate..will be even better when finished!

Mat C
06-10-07, 07:33 PM
Needs anodized end caps. I used to have a set of them on my ZR160, looked good with the whole bay done !

stamford
06-10-07, 07:40 PM
I know what you mean, just alot of work using them though, I've gone for the simple approach ;) heatshrink sleeving where possible. The end caps are more for the water hose though. I very nearly bought a complete engine kit when I was in the states, but it was a bit heavy and though better of it when trying to bring it home in the baggage!

Leasky
07-10-07, 12:57 AM
nice one buddy

Smokey
07-10-07, 01:55 AM
looking good!

arwilson80
07-10-07, 11:09 PM
Looks nice, and it's different.