View Full Version : stupid question
yellowzr
10-04-12, 06:33 PM
Hi all got my head gasket set stretch bolts water pump and cam belt kit today so the stupid question is whats the torque settings and order to do the gasket
thanks Paul
i also njeed to know this as well and what oil and antifreeze to get as think mine is shot drives ok dont over heat slight leak behind alternator ,but today i parked up in gear on a slight slope left in first gear and left handbrake off and it start to roll forward also turning engine over could this be poor compression ??????
yellowzr
10-04-12, 06:53 PM
yes mines in early stages just a slight coolant loss and a bit of oil getting in the water so doing it before more damage is done full service as well
Paul
big_wasa
10-04-12, 07:09 PM
You often get a bit of paper in the headset with that info on it.
yellowzr
10-04-12, 07:23 PM
not in this one lol telling me about new rails lol
Paul
big_wasa
10-04-12, 07:33 PM
ok some one will know it from memory, if not I will see if I can look it up.
edit
http://www.75andztclub.co.uk/showthread.php?t=100026
its 20 nm, then 180degrees, then a further 180degrees
run all the head bolts in by hand first, then torque in the following order
10 6 2 3 7
09 5 1 4 8
then go round again with the 20 nm torque, keep going round till they no longer move when torqued, you will find the first ones you did will move a bit
then if you dont have a torque angle gauge mark the head bolt with a pen with a start point, then do the same sequence with the 180degrees turns, at the end all the marks should line up with the original mark
yellowzr
10-04-12, 08:47 PM
thanks thats what I needed hopefully this weekend it will be done next the latest
Paul
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.