LHS wheel arch section of 180 bodykit, perhaps Mk2 alloy

[angry_muppet]

Had a small mishap this morning which has resulted in the destruction of various parts of the LHS wheel assembly. The only part that's going to cause me problems is the body kit...

Does anyone have the flare for the front LHS arch on a 180 kit? Any colour will do, black preferred.

Alloy should be ok, but may also need a single Mk2 11 spoke. Not too worried about condition as I've never got around to refurbing them. Were well kerbed when I got the car.

Unfortunately if I don't get by tomorrow, I'm off to Dubai on Thursday so won't have access to internet.

[petet16]

http://www.ebay.co.uk/itm/MG-ZS-MK2-V6-180-BLACK-PBT-N-S-PASSENGER-WING-FACELIFT-BODY-KIT-/230900314730?_trksid=p5197.m1992&_trkparms=aid%3D111000%26algo%3DREC.CURRENT%26ao%3 D1%26asc%3D14%26meid%3D5387305214286602981%26pid%3 D100015%26prg%3D1006%26rk%3D1%26sd%3D230900314730% 26

[angry_muppet]

Cheers, but I've found the little bit that was broken out of it when I was back at the site this evening... It should be reparable with plastic welding, but I'll keep an eye on that.

[petet16]

Thats good news, could save some ££

[angry_muppet]

Well, all repaired now and back on the road for the total sum of £280. I will still need a replacement alloy as the current one has a slight buckle in the vertical plane. It'll do on the back for now.

Some bodywork repairs needed yet to finish off the kit to a good look.