VIS pcb's

[petet16]

Would these be the same as the pcb's in zs vis motors ?

http://www.ebay.co.uk/itm/Rover-75-ZT-Balance-VIS-Motor-Replacement-PCB-V6-2-0-2-5-190-180-KV6-Engine-/281071903205?pt=UK_CarsParts_Vehicles_CarParts_SM&fits=Car+Make%3AMG&hash=item417130e1e5

[Craig-ZS180]

May be wrong but I was under the impression the vis motors were all the same. Im sure mine that are currently on the zs were off of a zt when I got them? Wouldve thought they would do the job.

[POMPSKI]

If they are, I hope he is prepared for a massive increase in demand

[petet16]

May be wrong but I was under the impression the vis motors were all the same. Im sure mine that are currently on the zs were off of a zt when I got them? Wouldve thought they would do the job.


I was pretty sure they were all the same, but his application lists only show zt/75 so I thought I'd stick the question out there.

[Craig-ZS180]

I was pretty sure they were all the same, but his application lists only show zt/75 so I thought I'd stick the question out there.

His listing does miss lead a bit I think as ive always been led to believe that the motors are the same on all the manifolds. Dont think there would be a difference between them.

[petet16]

I just checked the motor part numbers, they are the same for zs/45 and zt/75.

[DuckFeet]

Now if he could source oil resistant (brushless) motors these would be fit and forget surely?

[KevG]

This is Stocktake (Dave) on the 75/ZT forum who is selling these.

The PCB is for Balance only, and has a facility for adding a test switch, it also has solder pads for adding the outsource motor that he fits.

[DuckFeet]

adding the outsource motor that he fits.

Link please? I'll have a go at searching for it.

http://www.75ztcommunity.co.uk/vis-motor-pcb-design-t4384-20.html

[KevG]

All I know is that the motor are specially made for a company in America.

[DuckFeet]

I now have one of these. I've been meaning to build a test box for vis motors for ages so I'll report my findings when I get round to it. I may well put switchs on the actuators to test in situ as they have done.

[Witnes$]

You want me to post you an engine loom to build a test rig from?

Got 2 power and 2 balance spare. I know one set are definitely working but you could always work some magic, wink wink.

[DuckFeet]

Yes please buddy. I was going to ask about the loom in your breaker, although I thought you needed it more than I :whistle: is your VIS still wonky?

I probably only want the connectors but with all the wires I could mock up an input for throttle possition and rpm..? so I might as well have all of it.

Any spares you have would be great. Probably to rebuild and return as I'm looking at replacement switches and stuff, basically copying the fine work of the 75/ZT lot as it seems a shame to replace the PCB and leave the rest standard.