Replacing brake hoses how to.....?

[pb25]

I've seen a 'how to' for replacing brake hoses but can't for the life of me (or google!) find it now. I think it was for a Rover 400 but have checked mg-rover and can't find it anywhere. It's the one where the guy get slagged for using grips instead of a pipe spanner.

Anyone seen it or know where it is????

Any help appreciated as I'm planning on changing all 4 on the diesel Zed this weekend.

[Captain Peanut]

There's this one:

http://forums.mg-rover.org/showthread.php?t=326742

[pb25]

Thanks for that.....I found that today but it wasn't the one I saw before.

What size pipe spanner do you need for a zed diesel?

Sent from my HTC Sensation Z710e using Tapatalk 2

[petet16]

The rigid pipes are 10 or 12 mm iirc, it's worth giving the unions a good go with a wire brush and some Plusgas or similar.

[pb25]

Thanks for that......am off this week and drove the zed 600 miles to my parents with tools in so gonna do them here

Sent from my HTC Sensation Z710e using Tapatalk 2

[Ritchy]

Id lube up the unions in advance at least a day before hand,

[pb25]

Aye Ritchy....I did that yesterday when I freed the caliper slide bolts.

As a tip for anyone struggling with caliper slide bolts.....I used a blow torch to heat the caliper holder where the slide bolt fits into, then used a 15mm jaw fork type ball splitter and hammered them out.....takes about 10 mins for each one max even when they are well and truely stuck!

Sent from my HTC Sensation Z710e using Tapatalk 2

[MickUK]

Worth investing in a decent, wide spanner. Or even a brake pipe spanner.