View Full Version : Screws for stainless kick plates
Mart_in_MCR
04-10-13, 10:36 AM
Retro fitting these to my ZS and just wondering what the best size screw would be?
Thanks
Martyn
Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
You may find further informations here (http://www.themgzs.co.uk/vb/showthread.php?t=25376).
The screws's length must be a little more than 1" IIRC.
Mart_in_MCR
04-10-13, 12:39 PM
You may find further informations here (http://www.themgzs.co.uk/vb/showthread.php?t=25376).
The screws's length must be a little more than 1" IIRC.
Thank you, think I need some of the grommets mentioned in your thread too before I can fit them!
If you have a decent scrappie near you most older 400s or 45s will have them and can be removed and refitted in your car for much cheapness :)
talkingcars
04-10-13, 06:44 PM
The grommets tend to break as you try to remove them.
I used scrapyard screws to replace the rusty ones in FE54.
Mart_in_MCR
04-10-13, 06:49 PM
Thanks guys, will try the eBay link on the other thread as not sure I will get chance to get to a scrappy this weekend.
Does anyone know the screw diameter required?
Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
Supercharged_Z
04-10-13, 07:25 PM
honestly just get a couple of basic silver screws you will be fine.
talkingcars
04-10-13, 07:31 PM
honestly just get a couple of basic silver screws you will be fine.
Need to be stainless or coated, the rusted ones I had looked horrible.
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.