Bits of trim falling off...

[arwilson80]

...and you can't get the right fasteners to fix them back on?

Thy this site (http://www.bresco.com/acatalog/Fasteners.html) and see how you get on. :ohmy:

[Maxxed_Ross]

alot of those look like the right bits

Nice find!

[stamford]

There's a few others out there, my best find was at an autojumble. Hopefully they are not too expensive or have a minimum order quantity.

[arwilson80]

alot of those look like the right bits

Nice find!

Wasn't me that found the site... :smile2: I just 'borrowed' the link from theMGZR. :laugh:

There's a few others out there, my best find was at an autojumble. Hopefully they are not too expensive or have a minimum order quantity.

Most of them are packed in 10's, but they do seem a tad expensive - there doesn't really seem to be a pack less than £7.

[stamford]

If we have enough interest we could buy some bulk packs and then break them down on demand and sell them to members. 1st class would be good for sending.

Here's a couple of suppliers I have used:

Anixter Components (http://www.anixtercomponents.com/?gclid=CKbV-fHJ5JQCFQHilAoddB0LQg)

Moss Plastics (http://www.mossplastics.com/mss/mss-pc.nsf/WebEngine?OpenAgent)

[arwilson80]

If we have enough interest we could buy some bulk packs and then break them down on demand and sell them to members.

I had thought of that too...

[Alan.F]

Good link that thank you