Quote:
|
Well rear parcel shelf and all seatbelts have been removed so now I await the harness arrival.
Also greased the sticky rear caliper which seems to have helped. I sprayed another couple of engine bits green too so will get pics up when I fit them on again! Hoping my livery arrives in the next couple of days as it is all bought and paid for :D |
Ok, so harness arrived today and all was well until I tried to put the final bolt in.
This is the one that goes through the original subframe and into the floor same as Leigh's: http://i211.photobucket.com/albums/b...f/IMG_0327.jpg Problem being, the original bolt is tapered and therefore the hole narrows the deeper it goes (also the thread is a fraction wider I think) So how do I get the bolt in, as brute force seems to be failing!? |
Best way would prob be to tap it out to the size needed.
|
Quote:
|
I dont have a tap set :( Just a drill :P
|
I don't either or I would have offered u it
|
If it wasnt holding in a seat belt id suggest drilling it out 0.5mm small then just brute force approach
|
could always get one use it, carefully put it back in the case and take it back. ;)
|
That was my initial though but as you say, is holding a seatbelt!
Surely enough brute force should eventually get it in?!? |
All times are GMT. The time now is 01:17 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk