Spent a lot of time this weekend flaring brake pipes, I've cut off the section that is leaking and put a join in the existing pipe.
However I have since been told I shouldn't have flared the OE pipe as it is steel and wouldn't have made a good flare, so will leak. However even stamping on the pedal there is no leak I can see at all.... Am I risking a leak with this? Should I look to replace the whole line (which means dropping the fuel tank!) Anyway, both rear brakes (drums still!) are now braided and will get to the fronts when the weather clears up a bit. Whilst doing the front lines I will clean up the suspension a bit, and then its time to book it into an MOT :) |
don't they usually use copper pipe for the brake lines??
Not worth skimping on brakes, one thing I always keep up to spec. Good luck with it. :bow::bow::bow: |
Quote:
|
My lines are steel. Still in good condition. If you’ve managed to flare it and it seals then you should be okay. The copper section you have added will squash to the steel flare and seal when tightened.
|
the TF on its last MOT has advisories on a couple of brake pipe runs, front to back, that I need to get sorted.
Always something to do. |
Quote:
Quote:
|
Quote:
Have to see what pipes need doing, and then start worrying. |
When I changed the subframes on my MGF I changed the front to rear brake pipe and the 2 that go to the rear wheels. I had to re-flair one on the car when a bolt on the suspension came out (I thought the hole was threaded) and the arm crushed the pipe, strange thing is that it went through the MOT with the arm loose.
I also swapped the clutch line for a front to back one in with a braided hose supplied for the Lotus Elise. |
So... after all that work, 2 miles from the MOT station the engine decided that C4 rod should exit out the side of the block... and shower everyone behind me with engine components (it was running sweet as before hand with no issues or warning this was going to happen!)
Anyway... I refuse to let the ZS die, so I have now ended up with another Hatch T16 that needs a bit of work (although good engine etc) and plans are to make one really good car out of the two :) |
Gutted for you Sam. Hate hearing such shitty news. Hope you get some luck from now on.
|
All times are GMT. The time now is 04:26 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk