ZS MK2 Numberplate Bulb holder
 

Before I give Rim-yer-brother's my hard earned... Has anyone got a couple of MK2 Numberplate Bulb holders?

Rimmer's say this is the correct one: http://www.rimmerbros.co.uk/Item--i-XFC000160

But it doesn't look anything like the units I have sat in my bumper... then again the units i have don't fit! They just fall out and I can't do anything with them like changing bulbs etc...

Further, I spoke to my local MG Rover (ex) Dealer... who said it was a good part number (XFC000160) but since the picture is generic and my numberplate is listed as a MK1 (but only for the rear!!) he can't guarantee it will fit... - Do I risk ordering the wrong part???

XFC000160 is shown as the correct item for cars serial number 637209 onwards so if the number part of your vin is 637209 or higher then it will fit

Thats the correct part for mk2's

Ok, so my serial is 639... so that should fit?

how come my lenses look like this?

Attachment 4159
Attachment 4160

Actually, looking at that it looks like the loom has been cut as well... hmmm....

It certainly should fit.

I've just looked at your pics, they don't look like the original lights.

http://www.rimmerbros.co.uk/ItemImag.../XFC000160.jpg

No, hence my initial question... also you can see the loom has been cut and replaced with those spade connector crimp things...

So Ideally I need someone who is breaking a MK2 ZS Saloon! so I can get the bulb holders and a bit of wiring loom to repair this... Apparently any MK2 ZR, ZS, 25 or 45 will do!

It looks like it, as long as they haven't cut the mounting about to make the replacement lamps fit

Paint appears to be untouched on the bumper and the hole looks factory cut rather than Stanley knife cut... hmmm since its only a tenner for the two holders I might just buy them and work out a new way to fit to the loom...

Yes... well despite what I said earlier... The holes are way to big for the OE lamps, so stuck what to do now!

One of the "cobbled together units" is totally fried, even replacing the bulb (which took 30 mins to do) didn't get it to light up again!

Now as this is an MOT failure I guess I have five options...

1. Find some replacement fixings of the same size as these duff ones
2. Make up some sort of bracket to hold the OE lights in place (although no idea how to do that, I don't have a 3D printer or manufacturing equipment)
3. Replace the whole bumper - Guessing this would be very expensive!!
4. Use some MK1 fittings and self tappers to fix it to the bumper (fine for short term but will destroy the bumper further and be a pain to change bulbs in future)
5. Hand the car to a body shop and get them to fix the OE units in place

So, unless someone has a MK2 Rear bumper in Black locally going for cheap.... I will have to give this some thought!