Track project 180
So I had some spare time today so I decided to look at installing an induction kit.
Looking at the cramped engine bay on the ZS I decided there was little room for a filter and I don't want to cause heat soak by putting a cone filter directly behind the rad. So I thought I would construct my own cold air induction kit by using the original airbox and a pipercross induction kit I had lying around. Here are the pics of my creation: Firstly I removed the original airbox and then cut out part of the top section so it could house the cone filter. http://i221.photobucket.com/albums/d...0/9d615b90.jpg http://i221.photobucket.com/albums/d...0/d9cca597.jpg http://i221.photobucket.com/albums/d...0/a58a617d.jpg Then I cleaned out the oil and muck out of the out airbox and re-installed in back in the car. http://i221.photobucket.com/albums/d...0/bdced948.jpg This is the induction kit I'm fitting. http://i221.photobucket.com/albums/d...0/e83e3cd9.jpg http://i221.photobucket.com/albums/d...0/309ef4c4.jpg I played with the connections and trial fitted a couple of times before tightening everything up and finally fitting an oil breather. http://i221.photobucket.com/albums/d...0/8709fd22.jpg http://i221.photobucket.com/albums/d...0/b1b1090c.jpg I then took it out in the pouring rain for a test drive and I must say I am very impressed so far with the results and it's making some lovely sounds :) |
Not seen it done that way before.
TBH your better of just rooting the filter through to the passengers side of the bumper. Its very easy to do with plenty of room. You wont get any heatsoak that way. Filter looks a tad small for a 2.5 litre...? should flow enough air if its clean though Not sure you will be getting any any cool airflow that way because the std intake just roots to the inner bumper. |
I like that, a good use of the old panel filter housing. Have you considered a cold air feed using the old resonator link pipe at the bottom fed into the inner wing?
|
Quote:
I originally had the induction kit on my 3.2 crossfire so it should be fine I think |
Quote:
|
Quote:
|
that's certainly different!
|
Where is the cold air coming from? Bottom of standard airbox via a pipe to inner wing or from the resonator box?
|
Quote:
|
Different, like it because of that:) should work not too bad at all and very ingenious:)
|
All times are GMT. The time now is 11:59 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk