N/S/R Door Handle
I have noticed that when I open the passenger side rear door, the surround around the handle at the back, is coming away with the handle.
Is there a clip or fixing to hold it to the door? I know there is on the 1991-1996 Rover 200. |
Yes it's a bolt which goes into a metal threaded insert in the back of the surround, it sounds like the plastic has broken on the back of the surround and allowed the insert to come loose.
|
Do a search on repairing the handles and get it done before the other bolt goes.
|
Is there a article on here? My daughter I think may have pulled it off, after I put the origional piece on here!!!!!!!!!!!!!!!!!!!!
Can see the two bronze threaded bolts. Can they be glued back on? |
|
Read them. On investigation, it is the two brass ends, the plastic has broken away where my heavy handed daughter tried to open the door, before I plipped the CDL!!!!!!!!!!!
Have a few bodyshops as customers, can they just "glue the handle back on to the rods without having to take door apart??? |
Quote:
Apart from the drivers door there is only 1 rod to remove and all you have to do is spin the handle around it (note how many turns so you do the same when refitting). Obviously there is also the rod on the door card but you'd have to remove the card to get acess to the back of the handle anyway. Then use some arildate to glue the brass bits back in. |
1 Attachment(s)
Quote:
heres a pick of damage.... |
Have sorted the handle. Took door card off, handle off and epoxy glued it . Smothered the metal to the plastic. That should cure it. Tested it after 5 hours. Good as new, all I need to do now is to just stop my daughter from breaking the other 3!!
|
The other handles will break at some point, Older Rover 400/civic's have the bullet proof ones. I have a civic set on my MG.
|
All times are GMT. The time now is 05:53 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk