Piping
I managed to get a K&N filter with an ITG Style pipe for the throttle body so no messing about with a separate breather filter.
I have been given a light aluminum 45 degree bend and a straight peice by a mate at work and I just measured the ID and it is 73mm. I have never seen them that size before. I will need a 90 degree coupler but what size should I get? Bearing in mind that at one end it will attach to the hard plastic (ITG Style) pipe which I believe is 70mm as it was attached straight to the throttle body and the other end will attach to the 73mm aluminum pipe. Any ideas what will fit? |
All times are GMT. The time now is 02:22 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk