Cam shaft sensor A
 

Just went out this morning, turned to the car over but is just span without catching at all.

I thought the starter was given grief again, but when starting in gear it moved, so no that was fine.

In the end kept trying my flakey starter finally gave up, but after reading the Error logs, it says Cam Shaft sensor A 0340, now I'm sure that's why it didn't start in the first place, but is that the front or back bank, please be the front as the back is a pig.

Also why would the sensor fail over night, seems weird, rain or water related?

It's at the right hand end of the front bank, check the connector for damp would be my call.

Next to the oil filler cap
http://i4.photobucket.com/albums/y14...6/100_1340.jpg

Oh, good, I just assumed there was two, ie front and back bank, so its just one on the front??

I cant test nought at the moment, I have to get a new starter motor first, but I did remove the front cam sensor and gave it a clean, but will also check the wiring and earths when I get the new starter in.

If I were you, I'd be onto RedZ for that sensor ASAP. With mine, the thing wasn't starting properly for a while, especially when hot, and then once the cam sensor was replaced - sorted. You might not need the starter motor at all.

I do need a starter motor, its in pieces on the garage floor :)

Fair enough .... :)