VIS Indicator Kit
 

Jay or Kev are probably the best ones to ask but I plan to relocate my vis lights to the dial area.

To do this, I need the wiring diagram for the the LED part (I have the wiring already in place) Mine is the green/red LED setup.

I'm not sure if its just led's and suitable resistors, but any help appreciated.

Hope they can help as my indicators are gubbed as you know Blair.

You are the reason I'm gonna make a move on this project.

Sadly gonna have to find a blank when I do it lol!

That won't be a problem plenty of blanks on the cars in scrappies I've been to recently.

Thats good then. I have other plans for them.

I'm sure I've still got a few somewhere, I'll bring them with me when I come to pick the track car up

You'll need diodes and LED's, I can supply both but not your colours you have i have only green/yellow.

Whats the matter Grimster with the indicators?

Kev, strangely, his yellow one doesn't display very well, the odd flicker. We plugged in my one for the track car (same yellow led one) and it was the same. Then we tried my green/red one and no problems, showed all was well!

So technically we have two kits that don't work. I got mine from Jay though not you but I think it was your original build?

When I floor it all the lights go out completely and then the power one lights up normally as the balance switches off.like Blair says we tested with his later kit and it all works perfectly.had about four different repaired balance motors in it before we realised it was the indicators and not the motors lol.:wacko:

So, when do you want me to look at it?