KV6 ZS 180 Engine
 

Just had the owner of my old ZS, he is looking for a replacement engine after belting a rock in the road and putting a hole in the current engine. Have not seen it myself so can't give a more accurate picture of the damage than that. He did say he pulled straight over and turned engine off but that's all the info I have.

He wouldn't need a plenum or VIS as these were all fairly recent ish and working A ok.

Any help or advice I can pass on would be fine, have told him to add timing belt etc before installing new engine (assuming he definitely goes this route).

He is also based in Inverness.

What would need changed on this ane for going in a ZS?

http://bit.ly/14ZPi26

Dan still got his "Red" one???

Zred as well!!

Told him about Goldie so he should be getting in touch wi him, thought Dans engine had gone??

Thanks Peter!!

Mine's sold I'm afraid .... Shame - it's a good one and bound for a freelander in Nigeria !

Tis a pity but also well done, that's one well travelled engine :)

the one in my blue zs went to austrailia,hope shes still working lol,thats bad news though has he burst the sump?

Sounds like he is describing the sump, have asked him to send me a pic of the damage when he can.

Hi mate, tell him to get in touch. I,ll try sort him out