theMGZS.co.uk :: MG ZS forum - Screws for stainless kick plates

theMGZS.co.uk :: MG ZS forum (https://www.themgzs.co.uk/vb/index.php)

- General Discussion (https://www.themgzs.co.uk/vb/forumdisplay.php?f=14)

- - Screws for stainless kick plates (https://www.themgzs.co.uk/vb/showthread.php?t=26518)

Mart_in_MCR

04-10-13 10:36 AM

Screws for stainless kick plates

Retro fitting these to my ZS and just wondering what the best size screw would be?

Thanks

Martyn

Sent from my iPhone using Tapatalk - now Free

Djules

04-10-13 10:45 AM

You may find further informations here.

The screws's length must be a little more than 1" IIRC.

Mart_in_MCR

04-10-13 12:39 PM

Quote:

Originally Posted by Djules (Post 322412)

You may find further informations here.

The screws's length must be a little more than 1" IIRC.

Thank you, think I need some of the grommets mentioned in your thread too before I can fit them!

Maxfly

04-10-13 02:32 PM

If you have a decent scrappie near you most older 400s or 45s will have them and can be removed and refitted in your car for much cheapness :)

talkingcars

04-10-13 06:44 PM

The grommets tend to break as you try to remove them.

I used scrapyard screws to replace the rusty ones in FE54.

Mart_in_MCR

04-10-13 06:49 PM

Thanks guys, will try the eBay link on the other thread as not sure I will get chance to get to a scrappy this weekend.

Does anyone know the screw diameter required?

Sent from my iPhone using Tapatalk - now Free

Supercharged_Z

04-10-13 07:25 PM

honestly just get a couple of basic silver screws you will be fine.

talkingcars

04-10-13 07:31 PM

Quote:

Originally Posted by Supercharged_Z (Post 322458)

honestly just get a couple of basic silver screws you will be fine.

Need to be stainless or coated, the rusted ones I had looked horrible.

All times are GMT. The time now is 01:45 PM.