theMGZS.co.uk  :: MG ZS forum

theMGZS.co.uk :: MG ZS forum (https://www.themgzs.co.uk/vb/index.php)
-   General Discussion (https://www.themgzs.co.uk/vb/forumdisplay.php?f=14)
-   -   Tech question (https://www.themgzs.co.uk/vb/showthread.php?t=30976)

ZS Phil 17-10-16 08:42 PM

Tech question
 
just a quick one,

Do all ZS 180's, including the really early ones take their speedo reading from the ABS system?

Reason I ask is because I'm having a box built with an after market diff and just want to know if I need to worry about the speedo drive gear or if its redundant?

Cheers

ZS Phil 17-10-16 09:04 PM

Just kind of answered my own question by going out to the garage. My pre-project drive (well until it became a track car) 180 has a yellow blank where the speedo drive would be so I guess all ZS's are driven by ABS.

That said, I could have sworn my TD ZS had a gear drive in the box?

talkingcars 17-10-16 09:14 PM

Apparently not.

http://www.rimmerbros.co.uk/Item--i-GRID003597

JOHNDQ 17-10-16 09:36 PM

Both my ZS and ZR have PG1's and ABS but both box's have the drive etc there for the speedo transducer but its just got a yellow cap over them. I only know because I tried to see if I could use a transducer on the ZR to run speedo as I took abs off, unfortunately after testing on the Scope it wasn't possible as the ABS etc takes an analogue signal from sensor and converts it to digital to send to dash board

peterzs 17-10-16 10:17 PM

crikey, that was a tech reply!!

I'm used to the good old flexi speedo drive on my MGB's knew where you were with them.

All this modern space age stuff.

:):):)

carmadbaker 18-10-16 06:49 AM

I converted my zed to run on a gearbox drive sensor after removing my ABS.
Think it was from a Rover 400? I then used something called a "speedo healer" which amplifies or cuts down the input signal from the gearbox to drive the ZS speedo, the ZS speedo has quite a high input frequency requirement but the speedo healer sorts it

ZS Phil 18-10-16 07:06 PM

Quote:

Originally Posted by talkingcars (Post 372389)

I think that must be an error because no 400 had the V6 and all V6 45's/ ZS's had ABS so even if the box drive was present it wasn't used.

Quote:

Originally Posted by JOHNDQ (Post 372390)
Both my ZS and ZR have PG1's and ABS but both box's have the drive etc there for the speedo transducer but its just got a yellow cap over them. I only know because I tried to see if I could use a transducer on the ZR to run speedo as I took abs off, unfortunately after testing on the Scope it wasn't possible as the ABS etc takes an analogue signal from sensor and converts it to digital to send to dash board

What about if you converted the clocks to the non ABS ones? 2 different clock types on ZRs I believe.

Quote:

Originally Posted by peterzs (Post 372394)
crikey, that was a tech reply!!

I'm used to the good old flexi speedo drive on my MGB's knew where you were with them.

All this modern space age stuff.

:):):)

Haha, good to share the knowledge

Quote:

Originally Posted by carmadbaker (Post 372395)
I converted my zed to run on a gearbox drive sensor after removing my ABS.
Think it was from a Rover 400? I then used something called a "speedo healer" which amplifies or cuts down the input signal from the gearbox to drive the ZS speedo, the ZS speedo has quite a high input frequency requirement but the speedo healer sorts it

I was under the impression you were using 400 clocks too so surprised you needed to modify the signal. Or have you since gone back to ZS clocks? Got a link for the speedo healer? Not come across those before...

JOHNDQ 18-10-16 07:13 PM

Thats true yes but the speed is a lower mph. I'm going for a Race technology 2 pro dash I think so then can have logging and everything on dash in front of me plus I like that you can add the Gopro function to it so can have info over laid on the videos etc

carmadbaker 18-10-16 08:33 PM

Quote:

Originally Posted by ZS Phil (Post 372402)
I was under the impression you were using 400 clocks too so surprised you needed to modify the signal. Or have you since gone back to ZS clocks? Got a link for the speedo healer? Not come across those before...

I was good sir, got fed up looking at old style clocks (even with nice fresh dial backing) so i have since gone back to ZS clocks :)
https://www.healtech-electronics.com/products/sh/

ZS Phil 18-10-16 09:33 PM

Quote:

Originally Posted by JOHNDQ (Post 372403)
Thats true yes but the speed is a lower mph. I'm going for a Race technology 2 pro dash I think so then can have logging and everything on dash in front of me plus I like that you can add the Gopro function to it so can have info over laid on the videos etc

That will be nice, expensive, but nice.

Quote:

Originally Posted by carmadbaker (Post 372404)
I was good sir, got fed up looking at old style clocks (even with nice fresh dial backing) so i have since gone back to ZS clocks :)
https://www.healtech-electronics.com/products/sh/

Fair enough, had a quick look, I'll certainly have to bear it in mind if ever I need to drive the speedo from the box.


All times are GMT. The time now is 03:31 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk