stupid question
Hi all got my head gasket set stretch bolts water pump and cam belt kit today so the stupid question is whats the torque settings and order to do the gasket
thanks Paul |
i also njeed to know this as well and what oil and antifreeze to get as think mine is shot drives ok dont over heat slight leak behind alternator ,but today i parked up in gear on a slight slope left in first gear and left handbrake off and it start to roll forward also turning engine over could this be poor compression ??????
|
yes mines in early stages just a slight coolant loss and a bit of oil getting in the water so doing it before more damage is done full service as well
Paul |
You often get a bit of paper in the headset with that info on it.
|
not in this one lol telling me about new rails lol
Paul |
ok some one will know it from memory, if not I will see if I can look it up.
edit http://www.75andztclub.co.uk/showthread.php?t=100026 |
its 20 nm, then 180degrees, then a further 180degrees
run all the head bolts in by hand first, then torque in the following order 10 6 2 3 7 09 5 1 4 8 then go round again with the 20 nm torque, keep going round till they no longer move when torqued, you will find the first ones you did will move a bit then if you dont have a torque angle gauge mark the head bolt with a pen with a start point, then do the same sequence with the 180degrees turns, at the end all the marks should line up with the original mark |
thanks thats what I needed hopefully this weekend it will be done next the latest
Paul |
All times are GMT. The time now is 12:03 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk