Help needed with changing ecu
 

Hi, I have had loads of problems recently with my mg zs 1.8, 2004. After changing lots of parts I have been advised to change the ECU. I have now got one with the alarm box and one key fob, can anyone advise how to change the ecu and where is the alarm box located?
Thanks

If its a MkI then its behind centre console - remove rear part of console (with armrest and leccy window switches), radio, hazard and HRW switches, front half of console and you'll see it at the bottom of the dash support.

This is my MkI in process of getting MkII dash, alarm box is is fixed to bottom of that large metal frame, about 30cm in front of gear lever.
http://i187.photobucket.com/albums/x...6315/022-1.jpg

wow that looks quiet hard to do

Getting to the ECU aint too bad.
2 screws and 2 bolts to temove back half of console.
5 screws for front half (forgot that theres one behind / below radio once you get it out)
You can leave gearlever gaitor in place - just unclip it from console (get something under front edge, where rubber mat is), you can twist is sideways to pop it through opening in console as you get it out.

http://i187.photobucket.com/albums/x.../console-1.jpg

This is really helpful, thank you very much. I have tried to take the ECU out today but it has snap off security bolts on the cage surrounding it at the bottom, do you know how I can get these off?

I guess the head of the bolt would have to be drilled or ground off but not sure about access to them off hand.
Will have a look at mine in AM and see what I think, can't get to it at the moment

Thats fantastic and once again thanks for all your help.

Just had a look at mine and it would be dead easy, yours being slightly later has the security shield I guess ("g" below)

http://i187.photobucket.com/albums/x...y_6315/ecu.jpg

If you can get a hacksaw blade on the head you may be able to cut a slot like a screw head and simply undo with a screw driver, failing that cut a slot and use hammer and old screwdriver like a chisel to try and tap it undone.
Theres a very slim chance that a couple of taps on the head of screws with hammer will loosen them - rare it works but could be worth a try.
If above fails your looking at drilling or grinding heads off - drill could be unlikely due to access but something like a dremel with a grindstone in it or even a little grindstone in a drill, something like this (wear goggles though!)

http://i187.photobucket.com/albums/x...Stone_Burr.jpg

Whereabouts are you - someone may be able to give a hand.

To just change over ecu for now I guess you could cut the security shield as below and just cable tie / tape new ecu to old one for now, gives you a chance to get stuff together to do proper job.
http://i187.photobucket.com/albums/x..._6315/ecu2.jpg

I have changed the ecu and alarm box but I wouldn't have been able to do it without all of your help and the pictures you sent so a massive thank you. I am just going to take the car for a test drive so fingers crossed.
Once again many thanks

Good luck - hope its cured, what was it doing anyway?