rear reversing sensors
as my mk2 has had them removed,bought some off ebay,but they are too small,was the 180 fitted with these as standard,have had a look on rimmer bros etc,the ones i bought were 21 mm,too small,but seems the ones i need are maybe 25mm,cant find a measuring tape for the life of me,any ideas,i would rather buy a bumper,but there gonna be rare eh,any info appreciated
|
They did them specifically and are defo bigger than the usual ebay ones. I have MG ones fitted to the rear (came with the car) and fitted front ones myself from ebay so I know they are different sizes mate.
Problem will be getting them the same colour. Respray will work but may reduce response on them. |
I had a mk2 bumper that came with 3 sensors and 4 housing adapters, I removed these as I didn't want them, but I did notice that they are stamped BMW, so you may find the old e46 used the same sensors?
|
Quote:
Iirc I used a 27mm tank cutter for the rears. I then used a rats tail file to form the pips that stop the sensors from spinning. |
Quote:
I think your right, the E46 sensor looks exactly the same as does the module for them |
Quote:
|
thanks for the replies guys much appreciated
|
Quote:
If you need part no.s, i'll dig the bits out. |
Quote:
Thanks for the offer, I've got a mk2 set ready to fit, it was just that I noticed the E46 module looked exactly like the mk2 one I've got. |
All times are GMT. The time now is 04:35 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk