Odd knocking/clunk noise
Over the past few days, infact it was on the way home from Dans place last week when dropping off a vis motor my front doors on the zs have started getting an odd knocking / clunking noise when accelerating,decelerating and turning left or right. It seems to be mainly a change in direction that causes it although its most noticeable when pulling away from stand still and then changing into 2nd gear. Its louder from drivers side too, can almost feel it through the door card.
Now I've had the card off several times now, taken the horrible sticky polythene sheet out of the way and gone round tightening up every single nut and bolt making sure nothing's loose. The window motor seemed like the bolts were a tad loose but now all tightened up the ruddy noise is still there. There wasn't anything else that could be tightened or not that I thought of anyway but does anyone have an idea of what it could be? Is there anything else in the door that would move in that way to make a loud noise that's very noticeable. With door card off though was almost impossible to locate an exact area. If anyone's had a similar issue or has seen or heard similar I would be very grateful as its really doing my head in now. :( |
Try greasing the door latch and striker.
|
Quote:
Should I use a normal grease or anything in particular? |
Just the normal multi use grease will be fine
|
Quote:
|
Quote:
It has changed in the way that you can now feel a slight knock through the door card around the arm rest pad part just down from the pull handle. I have looked behind but still cannot see what could be causing it. Also driven without the doorcard on and still none the wiser (is difficult to look at the area whilst driving though, not the safest thing so cannot give it complete attention) If any other suggestions are out there, I will gladly give it a try as its really doing my head in now :( |
No idea mate - but you might need a full set of Red doors .... ;)
|
Quote:
Could start off making a harlequin ZS like the old polos they made lol. |
A couple of other things to check, the metal bar that stops the door opening too far has a tapered roll pin type thing on the a post, if the pin has worked loose it clunks when you open and close the door, also have you tried with the door open, lifting the rear of the door to see if it clunks.
|
The pin looks ok, tried to gently tap it in further today but wouldn't budge but it does still clunk when opening the door, usually at 3/4 way through opening it. The door has no movement when open, no knocks or anything when trying to lift it so everything there seems ok.
It seems very odd that its a very noticeable noise that happens on either a accelerating or braking motion. Even on gear change you hear it and as i said going round bends it does it too. Nothing seems loose as have taken the door card off several times and cannot see anything shifting whilst it makes the noise. Strange that you feel it though if arms on the doorcard :hmmm::hmmm: |
All times are GMT. The time now is 01:50 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk