theMGZS.co.uk  :: MG ZS forum

theMGZS.co.uk :: MG ZS forum (https://www.themgzs.co.uk/vb/index.php)
-   General Discussion (https://www.themgzs.co.uk/vb/forumdisplay.php?f=14)
-   -   Help me keep my sanity.....! (https://www.themgzs.co.uk/vb/showthread.php?t=26369)

pb25 13-09-13 07:53 PM

Help me keep my sanity.....!
 
Ok so after some rather vigorous car washing I managed to snap the aerial off the peugeot partner. The aerial had corroded so the base mount was u/s. Before I snapped it reception was spot on where ever I went. Bought a new base mount and aerial off the fleabay and fitted them.......crap reception! Roll on a couple of weeks, 3 base mounts and 3 aerials culminating in genuine pug parts and I still have crap reception. There is a little silver cylinder with a lid on that fits onto the bottom of the aerial cable ring roof end.....it just says MAG on it and it looks like it has a small circuit board ring in it but no power from anywhere............I'm losing my mind why it doesn't give me reception like it did. No water ingress, checked both ends of the cable and all is well and plugged in.......HELP

(you might wonder why I'm not posting on a pug forum......there is one but no-one helps apart from one patronising guy who never actually helps......he just makes my blood boil......so as this is my favourite forum someone might have some pug knowledge)

Sent from my HTC One using Tapatalk 4

petet16 13-09-13 08:09 PM

Bent coat hanger ? :whistle::pimp:

petet16 13-09-13 08:15 PM

More seriously, was the original broken one a genuine Pug item.

petet16 13-09-13 08:20 PM

I googled it and found an old thread about water seeping into the co ax cable, could this be the issue with yours ?

peterzs 13-09-13 08:24 PM

Just looked a pug site and found some information.

Someone said it must be earthed.

Another one said the amplifier must be connected, wonder if this is the pcb?? Any wires floating about where the new base plate fits.

This was one of the threads, sounds a bit like your problem.

http://forums.digitalspy.co.uk/showthread.php?t=1464878

Hope you can get it sorted.

:smile1::smile1::smile1:

Dan1971 13-09-13 08:26 PM

I assume you've checked the lead to the back of your head unit. Might have disturbed it ?

pb25 13-09-13 10:09 PM

Quote:

Originally Posted by petet16 (Post 320619)
More seriously, was the original broken one a genuine Pug item.

Yes I think it was the original aerial

Sent from my HTC One using Tapatalk 4

pb25 13-09-13 10:09 PM

Quote:

Originally Posted by petet16 (Post 320620)
I googled it and found an old thread about water seeping into the co ax cable, could this be the issue with yours ?

No I did check that but it was fine one day then sh*te the next

Sent from my HTC One using Tapatalk 4

pb25 13-09-13 10:11 PM

Quote:

Originally Posted by Dan1971 (Post 320624)
I assume you've checked the lead to the back of your head unit. Might have disturbed it ?

Yep had the head unit out and there is loads of room at the back (unlike the zed!) and the cable is good and tight

Sent from my HTC One using Tapatalk 4

pb25 13-09-13 10:14 PM

Quote:

Originally Posted by peterzs (Post 320623)

Someone said it must be earthed.

Another one said the amplifier must be connected, wonder if this is the pcb?? Any wires floating about where the new base plate fits.

Now this sounds like it could have legs......there are other wires up by the courtesy lights so I'll have a look.....maybe one slipped off and went up into the head lining the first time I undid the bolt......tomorrows job!

Sent from my HTC One using Tapatalk 4


All times are GMT. The time now is 03:03 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk