theMGZS.co.uk :: MG ZS forum - View Single Post - Fixed Saggy Bum and Fitted Reversing sensors!!

SheppeyTrio · 07-09-09, 09:20 PM

My car pre-work

Got the bumper off

For some reason i've got 1 clip different to the rest so i had to leave it as it was and not cut it down!?

Clips back in place.

Reverse sensors in place! I cut out the holes where the original sensors would've been! There's small rings once the dirt was cleared off!

Bumper back on car!

Unfortunately the bumper's been bumped before so the right hand side has dropped a little!

Unfortunately I also broke this plastic bracket on the drivers side when i removed the bumper! I'm going to try to fix it back on because a new 1 costs over £70!!

Next thing happening is to change the exhaust for a 4" Piper Cut Slash!
Should be interesting!!

07-09-09, 09:20 PM	#1
SheppeyTrio Member Join Date: May 2009 Location: Sheerness Posts: 1,078	Fixed Saggy Bum and Fitted Reversing sensors!! My car pre-work Got the bumper off For some reason i've got 1 clip different to the rest so i had to leave it as it was and not cut it down!? Clips back in place. Reverse sensors in place! I cut out the holes where the original sensors would've been! There's small rings once the dirt was cleared off! Bumper back on car! Unfortunately the bumper's been bumped before so the right hand side has dropped a little! Unfortunately I also broke this plastic bracket on the drivers side when i removed the bumper! I'm going to try to fix it back on because a new 1 costs over £70!! Next thing happening is to change the exhaust for a 4" Piper Cut Slash! Should be interesting!! Last edited by SheppeyTrio; 10-09-09 at 07:31 PM.