theMGZS.co.uk :: MG ZS forum - View Single Post - Project

Cally180 · 13-10-12, 11:14 PM

Ready to Race

..well almost, today I fitted the new 3 point harnesses and I must admit that it gives it that extra wee feeling that once your strapped in, That your about to go into Colin McRae Mode

also thought I do a bit of stream lining..

and a bit more stripping on the inside.

After getting the tyres reseal, just going to run with what I've got just now until I replace at a later date with racing tyres. All that is left is a service and strip more if possible.

I did start to make an attempt to remove the door cards, but without braking them I gave up ha! how do you remove the likes of the window winders and the front in general... as I said I started then got bored and got a hammer and chisel and took some anger out on the sound proofing on the floor

so what's left to do;

- Service
- Wash and clean
- tidy up centre console
- remove door cards and strip more where possible.

13-10-12, 11:14 PM	#36
Cally180 Member Join Date: Sep 2012 Location: Dumbartonshire Posts: 610	Ready to Race ..well almost, today I fitted the new 3 point harnesses and I must admit that it gives it that extra wee feeling that once your strapped in, That your about to go into Colin McRae Mode also thought I do a bit of stream lining.. and a bit more stripping on the inside. After getting the tyres reseal, just going to run with what I've got just now until I replace at a later date with racing tyres. All that is left is a service and strip more if possible. I did start to make an attempt to remove the door cards, but without braking them I gave up ha! how do you remove the likes of the window winders and the front in general... as I said I started then got bored and got a hammer and chisel and took some anger out on the sound proofing on the floor so what's left to do; - Service - Wash and clean - tidy up centre console - remove door cards and strip more where possible.