[Smokey]

Little bit of progress, not much more visually as I only need to wrap it!

Tablet is installed. It protrudes about 2-3mm which helps to remove it. This set up us for ease of taking it in and out of the car. After doing tons of research and experimenting on my own tablet, magnets appear to have no long term ill effects. I have install metal disks inside the table and magnets to the rear of the console and it seems to hold the tablet nice and firm without being impossible to remove.

The temp sensor is relocated as is the lighter socket to the cubby hole area.

All I need to do now is wrap the console and gaiter etc and test fit it to my car and run it about to make sure the vibrations don't knock the tablet loose.

Other than that, it's setting up the console front end.

Getting very close to completion!