theMGZS.co.uk :: MG ZS forum - View Single Post

ZS Phil · 10-02-15, 02:35 PM

It won't be with CAD, good old fashioned paper and a sharp pencil to make scale drawings. By the time I've learnt how to use CAD, I could be finished!

Who did you get the blank discs from?

Only trouble with getting the accord type r discs re drilled is the center bore is too large (70mm instead of the required 64mm). There are other 300mm honda discs with the correct 64mm center bore however they are then too thin (25mm as opposed to the required 28mm). Either way its a compromise so getting some "blank" accord type r discs would be best then get the 64mm bore and 4x100 studs drilled.

10-02-15, 02:35 PM	#68
ZS Phil Member Join Date: Jul 2007 Location: Lytham St Annes, Lancs Posts: 1,556	It won't be with CAD, good old fashioned paper and a sharp pencil to make scale drawings. By the time I've learnt how to use CAD, I could be finished! Who did you get the blank discs from? Only trouble with getting the accord type r discs re drilled is the center bore is too large (70mm instead of the required 64mm). There are other 300mm honda discs with the correct 64mm center bore however they are then too thin (25mm as opposed to the required 28mm). Either way its a compromise so getting some "blank" accord type r discs would be best then get the 64mm bore and 4x100 studs drilled. __________________ ZS Turbo!!cough (diesel)