Thread
:
MK2 MG ZR160 Track car
View Single Post
14-11-15, 06:35 PM
#
7
JOHNDQ
Member
Join Date: Nov 2015
Location: Bedford
Posts: 370
Next was to remove the 6 pins i needed from the small MEMS ecu plugs (for fuel pump relay etc) i didnt want to cut up the factory part of loom in case it ever went back to standard etc so i added in 6-way male and female micro JPT plugs....
And the finished job factory loom into my loom without any cutting or damage....
I also fitted flat switch
Switch below....
Quick test to make sure ecu seeing pedal postion....
Repairing the worn out gear linkage and fiting a Dark ice quickshift kit, this was a real pain had to heat and bend in the gear rods as you couldn't get 5th hardly at all as they rubbed really bad....
As so added a remote take off for oil pressure gauge to get it away from the sub-frame....
Putting in the base maps....
I also wiring the in the MIL lamp to act as a shift light....
And at last all back together for a quick test run....
JOHNDQ
View Public Profile
Send a private message to JOHNDQ
Visit JOHNDQ's homepage!
Find More Posts by JOHNDQ