|
Well, Got the cam ladders off today an noticed straight away a lack of cam position sensor on the exhaust cam. So its all she wrote on that one! Still glad I had a look into it an put it too rest!
Havent bothered porting out the inlets as there only 1mm smaller than the exhaust ports. An match up with no step to the lower inlets so seems a little pointless there unless custom lower inlets are used.
Might have a little look around for some 190 cams if any are going cheap, until then need to finish the exhaust, get a cambelt kit, water pump and stat. clean an paint engine. Go across the country to pick up another 180 in tahiti blue. Cant see the engine been in for POL but if I get my exhaust mani done in time I'll fit that to my car as it is to test!
Also anyone have much experience of advancing the timing by loosening the inlet main pulley an advancing that way. Going on the assumption that when the pulleys perfectly central on the camshaft, thats 0degrees. moving the pulley anticlockwise advances slightly. An moving the pulley clockwise retards?
There is no adjustment on link belt side.
|