theMGZS.co.uk :: MG ZS forum - View Single Post

KevG · 06-11-07, 07:53 AM

If it is the VIS motors (Balance and Power), then they are an easy fix depending on what is wrong with them!

Power Motor (Situated at the upper front of the engine) - Usually this is poor soldering on the PCB, resolder the micro switches and affix with a small self tapping screw.

Balance Motor (Situated at the Left hand upper side of the engine) - This is usually full of oil. due to the breather system on the KV6, so sometimes these can be cleaned, if not then a replacement will be required.

If, the internals of the Plenum chamber are knackered then the whole unit will need replaced, no other way I'm afraid.

06-11-07, 07:53 AM	#7
KevG 2007 Focus ST2 Join Date: Jul 2007 Location: Polomint City Posts: 4,826	If it is the VIS motors (Balance and Power), then they are an easy fix depending on what is wrong with them! Power Motor (Situated at the upper front of the engine) - Usually this is poor soldering on the PCB, resolder the micro switches and affix with a small self tapping screw. Balance Motor (Situated at the Left hand upper side of the engine) - This is usually full of oil. due to the breather system on the KV6, so sometimes these can be cleaned, if not then a replacement will be required. If, the internals of the Plenum chamber are knackered then the whole unit will need replaced, no other way I'm afraid. __________________ Last edited by KevG; 06-11-07 at 07:56 AM.