[JOHNDQ]

Next was to remove the 6 pins i needed from the small MEMS ecu plugs (for fuel pump relay etc) i didnt want to cut up the factory part of loom in case it ever went back to standard etc so i added in 6-way male and female micro JPT plugs....




And the finished job factory loom into my loom without any cutting or damage....



I also fitted flat switch Switch below....





Quick test to make sure ecu seeing pedal postion....



Repairing the worn out gear linkage and fiting a Dark ice quickshift kit, this was a real pain had to heat and bend in the gear rods as you couldn't get 5th hardly at all as they rubbed really bad....





As so added a remote take off for oil pressure gauge to get it away from the sub-frame....





Putting in the base maps....



I also wiring the in the MIL lamp to act as a shift light....


And at last all back together for a quick test run....