Been a little while but thought i'd post a little update, now i have some time to myself this Bank Holiday.
A few little set backs but only to be expected. I had to strip down the dashboard again after discovering a couple of problems with the K6 and the AIM Dash, both had to be shipped off for updates / repairs.
Both arrived back after a couple of weeks with the added benefit of the K6 being upgraded to the new 6+ Spec.
Added A Nice Logo To AIM Startup
C&C Engineering Made Me Up Some Custom Mounts For The Wheel Speed Sensors
Vented Fuel Filler Cap
Reyland Rear Brakes Added
A Few Mods Were Needed To Use The Stock Handbrake Cables
Had To Use 2 x Offside Cables as N/Side is 15mm Longer
Would Of Been Easier To Use The Wilwood Cables TBH!
Rear Door Stripped Ready For Fuel Filler
Vented Filler Cap Added
Fuel Cell Plumbed In
Brakes have all been bled and no leaks 
On To Programming the Dash & ECU and we are ready to try and start the motor. I intend to ask emerald to connect up and check over my setup before a start is tried.
Front Doors and Bonnet Have Been Dropped With Lee Costello To Replicate In FBglass or Carbon if Budget Allows
Keep You Posted How It Goes.
Cheers
Paul