[Smokey]

Well over the last few days a bit of progress has been done.

A test fit was done for the combination planned with tablet at the top, followed by stereo then atc.

Sadly the stereo need far more room than is provided even if the SCU is removed so it has been slightly rejigged to stereo, tablet, ATC.

So the mock up of this configuration was made and fits perfectly so the placement was secured and the joins filled and roughly sanded.



Then a couple of coats of black were laid down to show up the imperfections to begin the fine tuning.



Due to the setup, the ATC unit takes up the ashtray section and about 5mm of space from the cubby hole area. I await a plastic sheet so I can recontour this area into useable space.

Quick progress is being made so won't be long until this will be completed, hopefully within the week.