little update:
today I was fitting my new go faster parts
. Had a issue when on the track where it went into safe mode, and long story short it turns out to be the throttle body sensor.
its a built in unit so new throttle body was needed. could have went standard but found a guy down Sussex, and after talking to him and checking out his work (has a clio project himself) decided to get a machined and enlarged one from 60mm to 65mm along with a machined and enlarged lower inlet manifold.
the claim is an extra 10bhp +17ftlb
and all for under £200
a few New Vs old picture
just awaiting a new inlet gasket as shown..
looking foward to see how it runs now.
on a off note, been considering turning this 100% track and getting a run around to go shopping etc, and been considering a return to the ZS.... since they are going for buttons, if anything getting cheaper
