theMGZS.co.uk :: MG ZS forum - View Single Post

sneekyparrot · 10-06-12, 09:45 AM

Hi M8,
don't bother cooling yet until you have braided lines, flush the fluid and run something like EBC BF307 and run some decent pads. Then you need to measure whats going on using something like this.

http://www.hrpworld.com/index.cfm?fo...action=product

proper cooling would need someway of ducting it thru the disc rather than just blasting it into the area and you would need a way to control the flow ie: blank it off when it rains etc.

Agree: run it past Peter at vulcan

10-06-12, 09:45 AM	#7
sneekyparrot Member Join Date: Mar 2011 Location: Birmingham Posts: 1,327	Hi M8, don't bother cooling yet until you have braided lines, flush the fluid and run something like EBC BF307 and run some decent pads. Then you need to measure whats going on using something like this. http://www.hrpworld.com/index.cfm?fo...action=product proper cooling would need someway of ducting it thru the disc rather than just blasting it into the area and you would need a way to control the flow ie: blank it off when it rains etc. Agree: run it past Peter at vulcan __________________ Forced Induction Is The Way To Go