It's half term, the college is deadly quiet, so I thought I would take the opportunity to get the ZS up in the air & have a quick butchers.
Hmmmm...
Polybush..
Careful, you might fall in...
Being an engineering & motor vehicle lecturer I can use the equipment here. Will be knocking up a battery cover using this plasma cutter, plus the laser cutter to engrave it:
Yup, nice & tidy under there. Tyre treads are looking a tad low so will be looking at getting them replaced. Had an oil & filter change along with the gearbox oil a week before I got it so pleased with that.
Looking to upgrade the speakers at the moment as it sounds a bit tinny in there.
Lucky you! I had to service the van in the road yesterday.
BTW is that you pointing at the lathe?
__________________
By how much do those who have gained by war fall short of the number of those who have perished in it? No doubt you will reply that there can be no comparison, that the dead cannot be numbered, while the living who have been rewarded may be summed up with three figures.