|
rear bumper sensors
Iv been faffing around and iv decided to change the parking sensors, mine are bad jobs put on aftermarket by the prvious owner and there are just 2 of them, so i thought i would just get a set of 4 and swap them over and put 2 new holes in at the edges but hell, guess what, the existing sensors are not level with each other so it would throw everything out, i will try and find a pic but what can i do? the sensor is half a hole below where it should be.....
is it possible to fill, plastic weld or something small peices in to the bumper and either re-situe the sensors or go smooth without?!! aaaahhhhh
__________________
Searching for MG ZS TD MK2 with full kit....
Last edited by jamesc777; 07-04-11 at 06:59 AM.
|
Threaded Mode