Clown car

[adam]

Originally Posted by welshone

Have fun mate. Shame it's not the MG's first trip out

I know the B will be mapped soon and then more fun will be had!

[Maxfly]

Enjoy the brmski an well done on the pass, makes things a bit less pressurised to work through eh

[adam]

Originally Posted by Maxfly

Enjoy the brmski an well done on the pass, makes things a bit less pressurised to work through eh

Ta

Yup, got a year now to replace the rear wheel bearings although once I've found some that aren't £90 each (bloody Rimmers) then I'll probably be doing them sooner. Need to find out what my creaking is as well on the rear of Clown, my guess is the rear arb but I need to get under her again to have a good look around.

[petet16]

£32.50 on ebay

[adam]

Originally Posted by petet16

£32.50 on ebay

I'm assuming something like this will do....

http://www.ebay.co.uk/itm/25-45-99-0...item2337226531

If so bonza!

[petet16]

That'll do the job, you have rear discs, or drums ?

[adam]

Discs, so need to make sure I order the disc compatible ones!

[Maxfly]

I would also make sure you tell them it's a 1.6 so your covered by stating what type you need. I did get sent the wrong bearing once even though I had stated to the seller it was for the 2.5 they sent one for a 1.6/1.8 they swapped it over no problem but was a pita as I needed the part rapid style at that point

[adam]

Good idea!

I am finding that a lot of parts systems don't have my reg on them which is a right ******, I guess because it was registered so late, ugh.

[petet16]

The one shown in the picture is for discs, the abs ring for drums is a flatter profile.