Quote:
Originally Posted by Jay-ZS+
how difficult is it to wire up on a mk1 I wonder? obviously the bumper doesnt have the holes but thats ok I own a hammer
|
These are really easy to wire and fit.
Remove bumper! Mk2 are marked on the inside where to cut, Mk1 you will have to use your own judgment.
Wiring is simple! position the control box in the boot either to the left or right behind carpet. The red wire taps into the reverse light and the black to an earth then you plug this in to the control box. Then fit the sensors to the bumper and feed through a grommet at the back of boot (lift bumper into position at same time) and plug into control box. Finally plug in the bleeper to the control box and position appropriately.
Attach bumper and test: Job done.
Hugh