I need your help guys!
I purchased the locking tools from a supplier in Spain. These i believe are some Chinese brand unknown but for 80 euros there a bargain compared to ones i've seen on various sites.
I've watched the KV6 timing belt video on youtube about 20 times so i was confident about the job. I first checked the rear cams was aligned which they was and the crank was in the safe position. I was planning on changing the belt without removing the cam bolt. Went ahead and removed the tensioner, at this time i started to remove the belt from the right hand side.
The right cam then springed out of position which then knocked the timing position of the rear cams, since i removed the belt it then slipped on the left hand side and springed out of place.
I used the tools which aligned the right hand side correctly - Both to my timing marks and the rear cam lines are level straight. As shown here:
Right hand side rear cams:
Left hand side is completely out of sync for some reason. Does not align with my timing marks and either do the rear cams align:
Rear Cams:
Have i been a complete twit and done something?
Any help would be fantastic