ZS remote control car

[RudeDogg1]

Lol

[Martin_H]

Originally Posted by drewbles

can still get the bodyshells here


http://www.morfars.dk/rc/mg-zs-p-2236.html?language=en

spot on Drewbles!!

[Jason04r]

Maxxed - I didnt find my handled very well , what you think of it?

[drewbles]

Originally Posted by Martin_H

spot on Drewbles!!

no worries fella

[Maxxed_Ross]

Originally Posted by Jason04r

Maxxed - I didnt find my handled very well , what you think of it?

The supplied rear wing was far too big and made the car really twitchy. I ended up just using it on outdoor tracks and used a smaller one for indoor/ You can't really see it in the pics but the Morrisons car had an almost flat wing with a small kick right at the end

Other than that I can't say it handled any different to any of the other jelly mould shells out there

[Rocket Red]

Originally Posted by drewbles

can still get the bodyshells here


http://www.morfars.dk/rc/mg-zs-p-2236.html?language=en

no good if the car is nitro you would need a 200mm shell if yours is electric then i will just shut my gob

[Maxxed_Ross]

depending on the car it might still fit. Remember the shell is totally blank so you could just move the rear wheel arch forward a bit before you cut it out