Anyone have a part number for this?

[easytime]

Originally Posted by MG ZS STE

Just been in the garage to check and it looks fine, certainly didn't give me no lateral movement that I'm aware of. How can I check it now it's off the car?

I don't know to be honest. My mech used a 3 foot pry bar against the engine to test mine, but out of the car that would not be an option. Does the rubber part look intact, no cracks or missing chunks?

[MG ZS STE]

If you pull the mount to one side you can see a crack around the base of the shaft where it disappears into the rubber, but looks to be only surface deep to me.

[easytime]

Ok, here's the plan, I have bought the unit from ebay that was in the link. It is a total unknown so we will wait until it arrives and I can get a look at it. If it is worse that yours then I'll get in contact with you regarding acquiring your unit.