Bought some nice looking aluminium valve caps after some pikey robbed mine. Bad idea, just gone to check my tyre pressures and they are all stuck solid!! The caps have corroded onto the brass valves.
If you've done the same I suggest you take them off if you still can!
I came across a bag of caps left in our yard after a tyre fitter had changed some truck tyres - fitted a set to my wifes ZR and after 3 months found they had done the same - managed to get them off and lightly applied lithium grease to stop it happening again.
__________________
Former custodian of the legend that was FE54 - RIP
I had these as well I had mole grips with a cloth around them told the rubber part of the valve and another set to try and remove the cap luckily it worked.
Yep had this same problem on my zr years ago and used the same method as yourself to get them off. Since then I have always smeared a bit of Vaseline on the threads and have had no problems since. Should you no be checking tyre pressures mair than once per year though
Yep had this same problem on my zr years ago and used the same method as yourself to get them off. Since then I have always smeared a bit of Vaseline on the threads and have had no problems since. Should you no be checking tyre pressures mair than once per year though
Most likely they were down to 22. Might partly explain my sub 20mpg. Had a puncher today so tuck the spare on which was only inflated to 13psi! Got plastic caps on now and fully inflated tyres
Yep. bought some MG ones off ebay, put copper slip on the threads, then forgot about them until the monthly pressure check (cough).
Couldn't move them, used Grimmys method, mole grip on the valve and a small spanner on the caps and loads of pressure. Eventually got them all off, now nice black plastic ones fitted.
Linear Mode
