theMGZS.co.uk   Navigation

ArcadeModifications AboutNews Flyers Forum Events Home

Home
Go Back   theMGZS.co.uk :: MG ZS forum > theMGZS.co.uk > General Discussion

Reply
 
Thread Tools Display Modes
Old 14-01-19, 07:13 PM   #1
LukeZS96
Site Supporter
 
LukeZS96's Avatar
 
Join Date: Jul 2014
Location: Carlow Ireland
Posts: 376
LukeZS96 is on a distinguished road
Battery to boot conversion

Evening chaps! Just wondering if there is any guides on a battery to boot conversion? I tried asking on Facebook but I may aswell be asking fluffy the cat with the advice I've been given. Only main questions I have are what gauge cable to use for my main live feed going through the car and the best place for my earth point. I was going to use the bolt where the rear seat backs bolts to the chassis or use the rear light bolts but I am unsure which is better. Thanks in advance lads. I have to move the battery due to the intercooler pipe routing there is no room in the engine bay for the battery. If there has already been a "how to" guide done on this could someone please link it instead. I can't use the search function on my phone
__________________
------------------------------
theMGZS.co.uk Supporter
------------------------------
LukeZS96 is offline   Reply With Quote
Old 14-01-19, 07:54 PM   #2
p_b82
Smoky turbo weasel
 
p_b82's Avatar
 
Join Date: Sep 2008
Location: Bristol
Posts: 2,688
p_b82 is a jewel in the roughp_b82 is a jewel in the roughp_b82 is a jewel in the rough
I don't think there is a "how to" for it for the ZS but there are some videos out there for other brands.

It's a job on my list, but mostly so that I can build a custom airbox at the front as I had a few bits chopped out the front to get the single pass IC to fit.

Not sure the gauge, but you want to it to be pretty high & battery cable spec - better to over spec than under.

Seatback bolt could be a good earth - I'd probably not want to use the rear light area just because I'd not want to increase the risk of any potential shorts *in case" scenario.

It does depend on where you plan to put the battery as to whether you put your own earth point in as well - if you're mounting the battery tray and cutting some of the boot matt down, you can put your own earth wherever is suitable really
__________________
------------------------------
theMGZS.co.uk Supporter
------------------------------
__________________
Mods Fitted
Pipercross Filter; Full 2.5" 'Wingy' exhaust; Donny Custom Turbo outlet pipe; Custom injectors;
Uprated gearbox bearings; Helix Clutch; Quaife ATB; Upgraded clutch Hydraulics; FMIC; Ported Head; ARP headstuds; Leda coilovers; 'Brembodge' 326mm disks/DS2500 pads
Dieselpowered
Fitting Custom Hybrid Turbo (1856GTBv) & controller; Remap, swirlpot, lift pump
AMW Motorsports
Custom exhaust manifold & downpipe
p_b82 is offline   Reply With Quote
Old 14-01-19, 09:46 PM   #3
Street Elite
Member
 
Join Date: Jan 2018
Posts: 73
Street Elite is on a distinguished road
I used 16mm2 welding wire but tbh I think it needed to be bigger.
I use an audio splitter block where the battery used to be. Then drop a cable to the starter and the fuse box. Some just wire to the starter and then a 2nd from starter to fuse box. Will work either way.

I have a very large fuse at the battery end. As close to the positive terminal as possible.

I just drilled the floor in the spare wheel well and fitted an earth point. Whatever bolt you want to use. Make sure your getting clean metal, even if that means grinding some body/ bracket to make sure.

I pulled the original tray from the front end and drilled through the floor just in front of the rear passenger light cluster. Bolted the tray down there. If your desperate some batteries have a vent pipe you could drill through the floor too but I never did. No I'll effects that I'm aware of!


Drew
Street Elite is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:36 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright ? 2010 theMGZS.co.uk