Stamford’s ZS180

[maxtherotti]

You don't fancy the brembodge brake set up then?
Keep thinking about that myself

Rob

[ZS]

Originally Posted by maxtherotti

You don't fancy the brembodge brake set up then?
Keep thinking about that myself

Rob

Even with all the issues they have?

[petet16]

Originally Posted by ZS

Even with all the issues they have?

eh ?

[maxtherotti]

Originally Posted by ZS

Even with all the issues they have?

Only issues im aware of is the pads sticking in the calipers but not a issue if properly refurbed
unless im missing something??

Rob

[ZS]

Originally Posted by maxtherotti

Only issues im aware of is the pads sticking in the calipers but not a issue if properly refurbed
unless im missing something??

Rob

Issues I had were lower ball joint rubbing on the disks under hard cornering, even with the shims behind the discs and that wasn't lowered... Had pads sticking, but a refurb fixed that... Any more spacers and you need longer studs in the hubs and then your front wheels have a wider track than your rear wheels... (I really needed longer studs TBH)

Those are just the issues I had... there are loads more documented elsewhere...

[maxtherotti]

Originally Posted by ZS

Issues I had were lower ball joint rubbing on the disks under hard cornering, even with the shims behind the discs and that wasn't lowered... Had pads sticking, but a refurb fixed that... Any more spacers and you need longer studs in the hubs and then your front wheels have a wider track than your rear wheels... (I really needed longer studs TBH)

Those are just the issues I had... there are loads more documented elsewhere...

I shant bother then
just get some drilled and grooved discs when there shot then

Rob

[stamford]

Originally Posted by maxtherotti

You don't fancy the brembodge brake set up then?
Keep thinking about that myself

Rob

Can't justify the cost, the calipers cost a fair bit these days and still require a refurb. Anyway the standard set-up is more than adequate for my needs and have never had any braking issues, just fade when overworked on track.