its finally all done tb zs or carbon plenum - Page 5

Ritchy · 17-12-13, 07:58 PM

If there is confusion measure the resistance of the motor if possible, then divide 14 / the resistance, then add on 10amp to your figure and that should be about right for it.

Mark S · 17-12-13, 08:30 PM

Quote:

Originally Posted by talkingcars

but the standard ZS doesn't have EPAS.

Quote:

Originally Posted by petet16

Standard zs pas has no fuses, I'm confused. !

its an elctro hydraulic pump, hence ehpas.

similar to astra mk4, merc w168 etc.

there is no room for pas when fitting the wsr tb.

petet16 · 17-12-13, 08:38 PM

Thanks for clearing that up, the op didn't mention it was a non standard set up.

tb steve · 17-12-13, 09:33 PM

yes i have electric power steering

will get some better pic's for you all

tb steve · 17-12-13, 09:41 PM

Quote:

Originally Posted by talkingcars

Is the fluid up to the correct level?
How clean is it? very clean only changed 2 weeks ago
Does it bubble when the engine is running? no

Where is this fuse? in the fuse box
If the correct fuse is in there and it keeps blowing you need to find the problem, just increasing the fuse will increase the risk of damage, possibly even a fire.

but we dont know the amp'age of the pump in the first place if it is a 40 amp pump i need a bigger fuse in there so it can handle it , its flat out all the time (the pump that is )

tb steve · 17-12-13, 09:42 PM

Quote:

Originally Posted by petet16

Thanks for clearing that up, the op didn't mention it was a non standard set up.

sorry oppps

Supercharged_Z · 17-12-13, 10:34 PM

guys remember this is a throttle bodied car, the air con pump is gone, now where the altenator sits. The PAS was lost too so this runs EPAS.

Alan.F · 18-12-13, 04:05 AM

Really pleased you finally got it back m8, I take it you took it else where to get it finished?

Drew · 18-12-13, 05:29 AM

the original pump is quite small, it would be seem feasible to fit it elsewhere for someone who hasn't seen the car first hand.

Drew

tb steve · 18-12-13, 02:50 PM

Quote:

Originally Posted by Alan.F

Really pleased you finally got it back m8, I take it you took it else where to get it finished?

yes mate

track n road and a good job was done only taken him 2 weeks to do

and the epas pump has gone now we did check the fuse that was ok