Wheel Studs

[Bobdope2002]

Im such a **** for doing this and i cannot believe ive done it just after some oppinions

I change dover everything on this car and then forgot to tighten a wheel up and drove on it not far at all and the wheel was wobbling like feck im told

We tryed tighten the nuts up and now the wheel will not sit flush with the hub

im sure ive bent a wheel stud

do u guys recon the same??

And Can you Direct Me To A link where to get some new ones from

Bob

[Ritchy]

jack it up, remove the wheel and refit it, it might not tighten up right if its sitting on the ground slack

[Bobdope2002]

Originally Posted by ritchyp

jack it up, remove the wheel and refit it, it might not tighten up right if its sitting on the ground slack

we did that mate

tryed two wheels just incase id damaged a wheel or something but both were the same

Im Totally Pissed of with myself over it but its just the luck i get ya know

[MG6Turbo]

Do you ever think Tim that you and spanners and tools just dont mix !

Is it front or rear?

G

[Ritchy]

btw if it is a rear stud could just put a new hub on , about a 5 minute job providing the drum comes off without a fight

[Bobdope2002]

Originally Posted by Rovermgparts

Do you ever think Tim that you and spanners and tools just dont mix !

Is it front or rear?

G

rear right george

[MG6Turbo]

Bring it over bud lets look.

G

[Bobdope2002]

is it safe to drive???

[MG6Turbo]

hmm.. dont know.. I would drive it just down the rd as im in uttoxeter. up to you. im not around till tuesday though.

G

[Bobdope2002]

what as in a new unit in uttoxeter or living in uttoxeter