T16 mot

stamford · 01-04-17, 09:16 AM

T16 had its pre-MOT earlier. Failed on idle emissions and leaky exhaust. Exhaust being done tomorrow, idle emissions booked in next Friday, no point in me doing it as don't have the equipment to check etc. I was expecting more so quite pleased. They said it was chucking in too much fuel at idle which pointed towards a temp sensor, which I have just replaced! I checked its MOT history earlier and was surprised at how little miles it has done in recent years. Since June 2011 it has covered 4568 miles, since Sept 2013 only done 1210 miles and that includes the trip back from Wales when I collected it. Probably explains the condition of it being covered in so much greenage! Pete obviously didn't go out much. So all going well it'll be at PoL

grimmy · 01-04-17, 10:06 AM

That isn't a bad result really.my zs is still on its sorn although it has nearly a month on its mot but the back has been playing up and I can't do anything to it.I can see it in forty years being a barn find for someone.

stamford · 01-04-17, 10:21 AM

Last weekend I struggled under the ZS, gave up as it needed to be up on a ramp. If I kept at it I would only aggravate my back as well. I must get on the blue mk1 more as that could be a future barn find as well!

Ritchy · 01-04-17, 09:54 PM

lambda might be out due to the leaky exhaust

stamford · 02-04-17, 05:00 PM

Popped into Kwik-Fit this morning to get exhaust sealed. Too many joints blowing, they said it really needs some sections welding as there are too many joints, makes sense. So this afternoon I removed the whole system so I could clean the joints and assess the situation. There is a couple of joints where the splits are too long and not overlapping the other pipe. The front pipe has a bracket on the overlap, bit of a bodge. Anyway tried setting up the MIG welder to weld stainless but that went a bit wrong. Gas pipe blew off, nearly shat meself

So doubt if I can get it re-assembled and re-MOT'd before PoL. Had a bit of a downer today, feels like my MGs are never going to get finished! Days like today I hate cars and wished I never liked them!

talkingcars · 02-04-17, 08:49 PM

Sounds like the exhaust that "Zippy" botched on to my T16 maestro.

It shouldn't be too hard to adapt a diesel exhaust to run with the T16 downpipe.

Dan1971 · 02-04-17, 09:50 PM

Get to a custom fabricator and get it sorted. Nothing wrong with just getting someone to do stuff sometimes.

stamford · 03-04-17, 12:47 PM

Quote:

Originally Posted by Dan1971

Get to a custom fabricator and get it sorted. Nothing wrong with just getting someone to do stuff sometimes.

Don't have the spare funds at present. Committed to DIY and baby stuff! Cars are not on the list at present!

Dan1971 · 03-04-17, 01:24 PM

Quote:

Originally Posted by stamford

Don't have the spare funds at present. Committed to DIY and baby stuff! Cars are not on the list at present!

Baby stuff .... ofcourse - I forgot - Grandad .....

ZS · 03-04-17, 01:53 PM

Would the 180 exhaust mount on the T16 Mick?

If so I have a full stainless powerflow duplex sitting on the Green ZS (including decat) that you could use?